Carrier TP-NHP Manual do Utilizador descarregar pdf (Página 19)

A07227

Fig. 12 − Standoff

NOTE: Standoffs are provided as an aid when installing Equipment Control

Module on inside equipment or a solid wall.

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 7, 8 and 9.

13. Snap cover over top of Equipment Control Module. See Fig. 13.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Sem comentários

Carrier TP-NHP Manual do Utilizador Página 19