Carrier 38TXA Guide Guia do Utilizador descarregar pdf (Página 158)

158 Chapter 4

S:\agilent\83217\OPT001\BOOK\CHAPTERS\paramtr.fm

Parameter Descriptions

Introduction

Parameters are values you enter that optimize test environment or

conditions of the software. Many of the parameters are determined by

examining your test needs. Other parameters are determined by

performing measurements to calibrate items in your system. Default

values are set into the software. Some of these values are derived from

standard methods of measurement and some are derived from the radio

test standards that are applicable.

Parameters remain in battery-backed-up memory until you select a

procedure to run. If you wish to prevent them from being lost when a

new procedure is selected, you will have to save them in a procedure.

The first few capital letters in the title of each parameter indicate what

the parameter refers to:

CPA = Call Processing, Analog

CPD = Call Processing, Digital

RC = Running Conditions

RT = Receiver and Transmitter, Analog and Digital

RTD = Receiver and Transmitter, Digital

RX = Receiver, Analog and Digital

RXA = Receiver, Analog

RXD = Receiver, Digital

TX = Transmitter, Analog and Digital

TXA = Transmitter, Analog

TXD = Transmitter, Digital

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 213 214

Sem comentários

Carrier 38TXA Guide Guia do Utilizador Página 158