Carrier operating and maintanance Manual do Operador descarregar pdf (Página 28)

Rev. __________

Date _________

2.10

E. Unloading (upper deck)

Note: The main deck should be empty prior to unloading the top

deck.

1. Tilting

Tilt the upper deck and the lower deck into alignment. Assure that the

upper deck winch cable is taut. Be sure that the load is partially unsecured

prior to titlitng, but maintain restraint against movement in every direction.

2. Winch (upper deck)

Release the remaining bindings, except for the winch cable. Winch the

load down onto the main deck until it it centered about half way on the main

deck.

3. Roll, Tilt, and Winch

Roll and tilt the lower deck until the approach tip and the bumper tubes are

firmly on the ground. Using the upper winch control, winch the load safely

to the ground. Block the vehicle or apply the emergency brake after the

load is safely on the ground.

4. Finish

Finish the process by winching the cable back onto the upper deck winch.

Then tilt the upper deck back into it’s stowed position. Proceed to do the

same process with the lower deck. Be sure that all chains, binders etc. are

secured in a toolbox prior to driving. Be sure that the pto is disengaged

prior to driving, as this may cause damage to the PTO.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Sem comentários

Carrier operating and maintanance Manual do Operador Página 28